Induction Cap Sealing - Products - Sigma Flex
designs the most portable introduction cap sealar - Sigma Flex. It is specifically designed for hand held cap sealing, in low production applications.
230 V AC, Single Phase
Sealing Capacity (Avg. Output)
4 - 6 bottles / minute
20 mm - 120 mm
The system is small enough to carry and seal anywhere. Easy line relocation.
No water needed:
Water less, 100% Air-cooled Universal Coil capable of sealing a wide range of closure diameters.
Digital Soft touch membrane control panel:
For easy operator interface.
High efficiency, low loss cable allows for extended lenghts and shorter heat cycles.
Digital UP / Down Timer:
For accurate time recording and optimum sealing.
No tuning, no tools, just plug it into 230 V single mains power supply, set the timer and seal.
Rugged, built to last. This machine can be used continuously for 24 hrs. production.
Small in size but Big on performance, Sigma Flex will seal closures from 15 mm to
60 mm or 60 mm to 120 mm.
Induction Cap Sealing
© Copyright, Electronics Devices